Categories
Acid Descaling
Aerosol Products
Boiler & Closed System Water Treatment
Coil Cleaners and Sprayers
Cooling Tower Water Treatment
Everpure Products
Feeding Equipment
Gas Leak Detectors
Glycol
IAQ Assurance Program
Water Filtration
Insulation Products
Plumbing
Refrigeration Oil & Vacuum Pump Oil
Speciality Products
Total System Protection
Water Test Kits

Products: IAQ Assurance Program

Oxine

Oxine^®

A concentrated product that is EPA-Registered and formulated specifically for use in HVACR systems and duct work, including fogging and spraying.

Premier chlorine dioxide sanitizer and deodorizer.
Low toxicity and high efficacy against pathogenic bacteria.
It can be fogged or sprayed.
It kills odor-causing bacteria and germs.
Tested effective against Legionella, Stachybotrys (black mold), Aspergillus fumigatus, Staphylococcus aureus, Mycobacterium bovis (Tuberculosis) and numerous other disease-causing organisms.
Helps to reduce allergies.
Helps eliminate gram-positive and gram-negative bacteria,yeast, mold and fungi.

Test Organism	Contact Time	Concentration	Results
Alicyclobacillus acidoterrestris	10 min.	30 ppm	99.998% Kill
Aspergillus fumigatus spores	60 sec.	100 ppm	99.999% Kill
Bacillus cereus spores	5 min.	200 ppm	99.999% Kill
Campylobacter jejuni	30 sec.	30 ppm	99.999% Kill
Candida albicans	60 sec.	100 ppm	100% virucidal
Canine Parvovirus	10 min.	500 ppm	99.999% Kill
Cladosporium	30 sec.	500 ppm	99.999% Kill
Erwinia carotovora carotovara	60 sec.	50 ppm	99.999% Kill
Escherichia coli O157:H7	60 sec.	3 ppm	99.999% Kill
Lactobacillus sp.	60 sec.	20 ppm	99.999% Kill
Legionella pneumophila	60 sec.	25 ppm	99.999% Kill
Listeria monocytogenes	60 sec.	25 ppm	99.999% Kill
Mycobacterium bovis (tuberulosis)	10 min.	500 ppm	99.999% Kill
Newcastle Disease virus	10 min.	500 ppm	100% virucidal
Pediococcus sp	60 sec.	20 ppm	99.999% Kill
Proteus mirabilis	60 sec.	100 ppm	99.999% Kill
PRRS virus	60 sec.	312 ppm	100% virucidal
Pseudomonas aeruginosa	60 sec.	5 ppm	99.999% Kill
Pseudorabies virus	10 min.	500 ppm	100% virucidal
Saccharomyces cerevisiae	60 sec.	30 ppm	99.999% Kill
Salmonella choleraesuis	10 min.	500 ppm	100% virucidal
Salmonella typhimurium	60 sec.	100 ppm	99.999% Kill
Stachybotrys chartarum	60 sec.	100 ppm	99.999% Kill
Staphylococcus aureus	60 sec.	30 ppm	99.999% Kill
Streptococcus faecalis	60 sec.	100 ppm	99.999% Kill
Streptococcus faecium	60 sec.	100 ppm	99.999% Kill
Trichophyton mentagrophytes	5 min.	500 ppm	100% Kill

As required by the EPA, the treated area must be evacuated prior to the application. Once the area has been treated, the area should be ventilated and allowed to air for on hour before repopulating. No one other then applicator should be allowed in work area during treatment.
To ensure absolute duct sanitation, the system must be mechanically cleaned, vacuumed, or blown free of dust, mold, soil debris prior to using Oxine-HVAC.
Cover all air vents with filter media and use drop cloths around work areas, as this product may fade some fabrics.

Application Method 1

Spray of fog Oxine-HVAC into duct work, coils, drain pan and grills. For best coverage, access system at each vent, or cut access holes for longer runs. When fogging utilize the Nu-Calgon Bio-Fresh Fogger (Part Number 4693-0) To insure adequate coverage place system under postive pressure with system fan.

Application Method 2

Place system under negative pressure with duct vac. Spray or fog Oxine-HVAC into duct work, coils, drain pay and grills. For best coverage, access system at each vent, or cut access holes for longer runs.

One of Oxine-HVAC's trademark qualities is its low toxicity and safety rating of the EPA. Rated as a Category III, Oxine HVAC does not leave an active chemical residue, and quickly degrades to simple table salt.
Oxine-HVAC does not use an propellants or flammable ingredients, enhancing its safety qualities.
Oxine-HVAC is a no rinse product, making it very easy to apply. Once Oxine-Havc is applied, it dries leaving the system virtually residue-free.

Oxine-HVAC should be applied by the applicator wearing a NIOSH / MSHA approved respirator with a
Organic Vapor / Acid Gas Cartridge
Secure proper respiratory and eye wear protection prior to activation.
Pour 3.25 fl. oz of Oxine concentrate into a suitable one-gallon mixing container
Mix and let stand for 5 minute before dilution
Prepare solution in a well ventilated area. Avoid breathing fumes that may be produced while crystals are dissolving
After mixing, add one gallon of clean water to the activated Oxine-HVAC. Dilution ratio is 1:40. Final use dilution is 500 ppm. Each gallon will treat 1,000-1,500 linear feet of duct surface. Mixed solution is good for up to one week when stored in a closed container away from direct sunlight.

Description Size Part # Oxine 3.25 fl. oz 4295-12