Products: Coil Cleaners and Sprayers

No. 300P Poly Sprayer

No. 330CP Poly Sprayer

The No. 330CP Poly Sprayer is constructed of high-density polyethylene. It has a funnel top which provides for easy chemical pouring and has a 3-1/2 gallon capacity (3 gallon working capacity). It comes with a 10" polypropylene pump, handle, 12" tube with adjustable nozzle and 3 ft. hose.

The No. 330CP Poly Sprayer can be used for spraying solutions of CalClean, Special HD CalClean, Alka-brite, Nu-Brite, Coil Pow'r, Evap Pow'r-C, Cal-Brite, and Cal-Shield on air conditioning cooling coils, air-cooled condensers, finned heating coils, refrigeration case or cooler coils, permanent air filters and other greasy, dirty surfaces.

Operation

  • Inspect sprayer, and insure the hose is securely attached to the tank and to the shut-off handle.
  • Remove the pump from the tank by turning counter clockwise.
  • To minimize foaming when preparing a cleaning solution, add water to the tank before adding the cleaning solution. Fill Tank to fill line on side of tank.
  • Close tank by inserting pump assembly through opening. Turn cap right (clockwise) until pump is sealed tightly into the tank (hand-tighten only).
  • Pump plunger to compress air and create pressure in tank. Twenty strokes of plunger provides a good working pressure. As pressure drops during use, recharge with 20 or more pump strokes. More strokes will be needed if the tank is not full, or as the sprayer is used and the pressure drops.
  • The nozzle tip may be adjusted to provide a single-needle stream (tip screwed all the way out) or a fine mist (tip screwed all the way in). Spraying time will vary from about 5 minutes with the needle spray to about 12-15 minutes with the fine mist. The needle spray should be used on finned coils to reach the third and fourth banks better. The mist is better for cleaning permanent filters.
  • Allow the cleaning solution to remain in contact with the dirty surface for about 15 minutes, then flush with water from a hose. If a hose is not available, fill the sprayer with water and flush using a course spray.

Packaging

Description Size Part # No. 330CP Poly Sprayer 1 Each 4772-1    

Product Literature Downloads:

No. 330CP Poly Sprayer - Product Bulletin

 

Back to top >

All Rights Reserved © 2008 Nu-Calgon. Calgon is a licensed trade name.