Products: Coil Cleaners and Sprayers

Nu-Brite^®

From the makers of the first coil cleaner...CalClean, and the first non-acid foaming, brightening coil cleaner...Alka-Brite...now comes the most revolutionary coil cleaner...Nu-Brite, the ACID ALTERNATIVE. It's easy to remember because it's blue in color. Ask for it by name or tell them you want "The blue coil cleaner".

A non-acid, alkaline-based product for cleaning and brightening air cooled condensers. It is formulated with the best available foaming detergents and chelants to quickly penetrate and dissolve greasy dirt and grime and foam it right out of the coil. The safer alternative.

Benefits

• Cuts through grease, dirt and grime better than acids.
• Foams like acids.
• Brightens as well as acids.
• Safer than acids.
• Biodegradable.
• Nu-Brite has been authorized by the U.S.D.A. for use in federally inspected meat and poultry establishments.

Application

For cleaning and brightening air cooled condensers and other finned heating and cooling coils located outside. It is an alkaline based cleaner that does all that an acid will do without the danger of an acid. Nu-Brite's state-of-the-art surfactants and cleaners instantly penetrate and lift layers of oily grime and corrosive deposits from the coil. Its foaming action pushes this loosened debris out of hard-to-reach areas restoring equipment to peak efficiency. It is not recommended for indoor use or on evaporator coils.

Directions for Use

1. Use only on condenser coils, or other finned coils that are located outside.
2. Goggles, gloves and other protective garments should be worn when using this product. System should be shut off.
3. Apply with the No. 300P Sprayer, No. 200P Sprayer or other durable, low pressure plastic sprayer.
4. Prepare cleaning solution by mixing one part Nu-Brite with three to four parts of water. Add the water to the sprayer first, then add the cleaner. If using the No. 200P, you will add the Nu-Brite first.
5. Spray cleaning solution onto dirty coils or surfaces and allow it to remain in contact with the dirty surfaces for 5-10 minutes.
6. Rinse thoroughly with water, and return the system to service.
7. Rinse out sprayer as well as its spraying wand and nozzle.

Packaging

Product Literature Downloads:

MSDS Information
Clean Coil Program Flyer
Nu-Brite - Product Bulletin
Good Practices & Procedures for Coil Cleaning
How to Clean Air-Cooled Equipment and Filters - Application Bulletin

Back to top >